Some things can be taught
March 6, 2017 § 22 Comments
How many times have you seen a group of cyclists spread all over the road like a warm breakfast? Judging from the rarity of organized, disciplined, 2 x 2 pacelines, you might think they are formations that only come into existence after years of practice. And you might think that the only people capable of riding mile after mile a few inches from their neighbors’ bars and a few inches from the wheel in front of them is the mark of a truly expert cyclist.
That’s what I always thought, mostly because the only time I ever saw functioning large groups ride like that they were composed of (accomplished) bike racers.
My club, Big Orange, had a Paceline 101 seminar yesterday. We all gathered on Westchester Parkway, and several of the club’s leaders put on the seminar. There were over forty riders. At least half had never ridden in a 2 x 2 paceline before. Most of the others had been riding for two years or less.
The Big O paceline, when I describe it, sounds goofy because of the silly names. Here they are:
“Horsemen“: These are the 6-12 riders at the front. These are the only rotating riders. Their job is to:
- Maintain steady power. Steady on flats, slower on hills, faster on descents.
- Give plenty of room around road hazards. Give wide berth to cones, potholes, sticks, big rocks, etc.
- Call out road hazards.
- Pay attention to upcoming stop lights. Anticipate when the light will change by watching crosswalk countdowns. Avoid panic stops and avoid running the entire peloton through red lights.
- Accelerate slowly from stops, remembering that everyone behind is still standing
- Rotate in pairs. Get off the front if the partner wants off. Left side swings off to the left, right side swings off to the right. Keep steady speed when rotating off the front, flick elbow and take 2-3 strong pedal strokes as you move over.
- Control the lane. The right hand rider controls positioning and stays just to the left of the fog line.
- Control descents. This is the hardest part to master, requiring a hard effort to keep speed on downhills until the rear of the peloton has completed the descent. Riders at the front cannot slow down until everyone has completed the descent.
- Steady ascents: Slowing too rapidly at the bottom of the hill means those at the end of the peloton will accordion. Slow gradually while climbing and regroup after crossing the top. Gradually lift the pace again after the regroup.
“Gatekeepers“: The two riders directly behind the horsemen. Their job is to:
- Maintain steady power. If the horsemen surge, the gatekeepers allow the gap to open, then slowly close it.
- Provide space for horsemen who have rotated off the front and are coming back in order to slot back in.
- Prohibit the peloton from mixing with horsemen. The idea is that one group, horsemen, do the work, and the other group, the peloton drafts for the duration of the ride.
“Buffers“: 1-3 pairs of riders, riding immediately behind the gatekeepers. Their job is to maintain steady power. If the group ahead surges, the buffers let them go, then gradually close the gap.
“Peloton“: This is everyone else. Their job is to:
- Stay on the wheel in front. Do not pass other riders. Do not fill in gaps ahead of buffers. Do not get out of formation to bomb descents.
- Keep handlebars even with your partner. Formations stagger when riders are not even with each other.
- Change lanes from the rear. When changing lanes, the rear of the peloton should move over first, after checking for traffic, and call out “Clear!” so the riders ahead know it is safe.
- Anticipate slowing riders in front. When approaching rollers, give extra room ahead. Know the route!
- Identify final rider position. Last place riders in the peloton should tell other riders “I’m last” if for some reason a rider is rotating all the way to the back of the group. Final riders should also take responsibility for being the riders who check first for rear traffic when getting ready to change lanes.
Before going to the Peloton 101 seminar, participants were supposed to have read this explanation of paceline riding. Once we assembled, a couple of leaders explained it all again in person, took questions, we did a practice lap around the Parkway. There was a lot of talking and some correcting, but no shouting or abusing or screaming. Everyone was told beforehand that we were there to learn, and told not to take anything personally.
Incredibly, no one did.
After the first lap we debriefed, people switched up positions, and we did a second lap, this time at about 22-24 mph. We debriefed again, questions were taken, and we rode a final lap “at speed.” After a final debrief, those who wanted to rolled with the group out onto PCH and practiced pacelining in the lane at speed all the way to Malibu and back.
What amazed me about the practice was how quickly people got it when it was explained and they had a chance to practice. After the second lap the 42-person rotation was so disciplined that, sitting at the very back, I could see all the way to the front through the gap between the side-by-side riders. It was almost perfectly straight.
I wondered why it was so effective, and several things occurred to me.
First, it’s not complicated, but there are organizational elements that need to be explained. I learned to ride a paceline while doing it, making a mess of it, and getting yelled at. Being calmly instructed, gently corrected, and given a chance to practice takes most of the terror out of it.
Second, having roles with names is a huge help to beginning riders. Sure, “horsemen” sounds silly, but it is a defined word with a defined function, and when you’re doing your first paceline with a bunch of experienced riders and you’re so nervous you’re about to crap your shorts, it makes all the difference in the world to have words tied to actual functions and roles.
This nomenclature also makes new riders concentrate on what they’re doing, as opposed to riding in terror that they’re about to crash out fifty people. Even better, once people feel comfortable in one role, they can try a more challenging one, so they not only have a place, but they have the feeling of “moving up.” Roles also have the invaluable function of predictability, which is what safe group riding is all about. There’s never any question about where a horseman is supposed to be, and if there is, you can ask. Compare that to the amorphous glob of riders in which random people do random things for no apparent reason … or at least that’s how it seems to beginners.
Third, holding a more-or-less permanent position throughout the ride means you get to know the person next to you, and the relationships are what makes the experience fun.
Removing the mystery, sharing the knowledge, and teaching skills raises everyone’s ability, including the teacher’s. It also creates a vibe in which people want to excel. Best of all, this method includes riders of vastly differing abilities and solves one of the biggest issues of group riding for clubs, i.e., “How do you integrate slower riders with faster ones without either shredding the slow ones or making the fast ones go so slow that they no longer want to do the ride?”
Every club should look at its mission and if part of the mission is education, improvement, and making road riding more accessible to more people, then a program like this is a winner. Photos courtesy of Joann Zwagerman, Big Orange phenom who was responsible for organizing yesterday’s seminar!
For $2.99 per month you can subscribe to this blog and get none of the news that’s fit to print but all the news that’s fun to read. Click here and select the “subscribe” link in the upper right-hand corner. Thank you!